Assembly & initial set-up
10
inner and outer drivelines to be sure universal joints are
properly secured.
Hold inner and outer drivelines parallel to each other:
Make sure
dimension “D” is at least 1”.
If needed:
a.
Mark drivelines halves at the correct length (“C”) to
cut.
b. Remove drivelines halves from tractor and gearbox
shafts.
c. Remove the driveline guards.
d.
Cut the “inner and outer drivelive tubes” off the same
required length (distance C).
e. Deburr edges of the drive tubes that were cut with a
file and remove all filings from the tubes.
f.
Cut the “inner and outer drivelive guards” off the same
required length (“C”)
.
A.
Grease the internal driveshaft tube.
B.
Reinstall the guards.
Assembly options
Please see your dealer for a complete list of updated
options.
Extended wings kit w/ drift cutters
#701046
Please see instructions included in the kit.
Snow drift cutters kit #701047
Please see instructions included in the kit.
Initial set-up
Please see adjustment section for the entire settings and
make sure the validation of the PTO drive shaft have
been made (see section assembly and initial setup).
D
Summary of Contents for BER3PTSB48R
