PRIMARY CHECK UP
MAINTENANCE
1
2
3
Checking Engine Oil Level
• Check the engine oil before starting the engine or ‘5’ minutes or more
after the engine has stopped.
• To check the oil level, draw out the dipstick, wipe it clean, insert it and
draw it out again. Check to see that the oil level lies between the two marks.
• Add oil only when the oil level reaches the lowest mark.Recommended oil
-“Mahindra M-Star Genuine Engine Oil / API CH-4 SAE 15W40 Oil
CAUTION
-:Do not run the engine if the oil level is low than specified.
Checking Coolant Level
• Check coolant level in recovery
bottle & Top-up if required.
• Use redimix coolant for top up.
WARNING -:
Do not open the
coolant cap when
the engine is hot. Do
not remove the
radiator cap when
the engine is hot
Checking radiator fins
• Clean chaff guard daily or earlier if chocked.
• Blow compressed air through the radiator fins to remove foreign material
NOTE -:
Radiator fins must be free of dust or chaff to prevent the
engine from overheating.
CAUTION -:
To avoid personnel injury, ensure to stop the engine
before working on radiator.
4
5
⚠
⚠
⚠
⚠
Check clutch pedal
• With clutch fully engaged pedal should have
free movement of 20 – 25 mm
Check brake pedal
• Pedals should have free movement of 25-30 m.
1
9
Checking fan belt tension
The tension is correct when the belt can be pressed
by thumb to 9 - 12 mm.midway between the two
pulleys without much effort.
In case the
tension is not
correct the
adjust the
tension by
adjusting
alternator
position on
brace plate.
Summary of Contents for Jivo 245 DI
