SWIVEL HOUSING SUB ASSEMBLY
4WD FRONT AXLE ASSEMBLY
SIDE HOUSING SUB ASSEMBLY LH & RH
1
4
Assemble the
Bearing 28X58X16
(006515144Y1)
with Bevel Gear
I n t e r m e d i a t e
(006513290Y1)
& Assemble it
to Side Housing
A s s e m b l e
the Circlip
(006505629D1)
to Side Housing
Inner Groove
Assemble bear-
ing 35X80X21
(000016299P04)
in Bevel Pinion
i n t e r m e d i a t e
(006513289Y1).
Assemble it to
Side Housing
Fit the O-ring
(006513337Y1)
to Side Housing
Outer Groove
A s s e m b l e
the Spacer
(006513385Y1)
to Side Housing
2
5
3
33
SWIVEL HOUSING SUB ASSEMBLY CRITICAL SETTINGS
On Swivel housing, measure the GAP from bearing resting
face to Swivel housing flange using tool “AGFAYNMG 003”
For Example-
Master height = 35.00 mm
Measured reading = - 0.208 mm
GAP = 35.000 + 0.204 = 35.208 mm
Measure float of Bevel pin
-
ion Intermediate (26) with
dial gauge or feeler gauge.
Float should be 0.20
mm (maximum).
Adjust float with shim
CRITICAL SETTING
Summary of Contents for Jivo 245 DI
