9
DANGER, WARNING, AND CAUTION
DECAL SAFETY MESSAGES
0595-2190 CAUTION DECAL
To prevent bodily injury and loader instability when detaching loader, equip loader with a material bucket.
0595-3050 DANGER DECAL
To avoid serious injury or death:
Unload only on a level surface.
Keep bystanders clear of work area when loading and unloading bales.
0595-3051 WARNING DECAL
Do not operate without confirmation that coupler pins are fully engaged.
Loader attachment can fall off if not properly attached.
To avoid serious injury or death:
Only use loader manufacturer approved attachments.
Read all operators manuals and decals before operating. Follow all safety operating and service instructions.
Contact dealer for replacement parts.
0595-3052 WARNING DECAL
To avoid serious injury or death:
Do not use pallet fork attachment to lift large objects, round bales, or items that may roll or slide down loader
arms onto the operator.
Always transport loads with pallet forks low and level to ground.
Always keep pallet forks level when raising loads.
Avoid raising loads to full heights with pallet forks rolled back.
ROPS (Roll-Over Protective Structures) and seat belt equipped tractors are recommended for operator use in
all pallet fork operations.
Do not lift or carry anyone on buckets, forks, probes, or any other portion of the loader or loader attachments.
Do not allow riders on tractor, loader, or forks.
Avoid contact with electrical power lines by loader or attachments.
0595-3053 WARNING DECAL
Maximum load limit on combined pair of forks is 3700 pounds.
0595-3054 CAUTION DECAL
To avoid serious injury or death:
Read operators manual and decals before operating.
Follow all safety operating, and service instructions. Contact dealer for replacement.
Be careful during loading transporting, and stacking to minimize rolling bales and tractor tip over. ROPS (Roll-
Over Protective Structures) and seat belt equipped tractors are recommended for operator use in all bale
probe operations.
Do not allow riders on tractor loader or bale probe.
Avoid loading/unloading bales on sloping or uneven surfaces.
Avoid transporting with bales raised high. Keep bales tilted back and low to the surface while moving.
Approach, penetrate, and transport bales at low speeds. Reduce speeds on curves, hills rough ground, or
when turning.
Do not lift anything with bale probe except round bales.
Never raise round bale to full height with bale probe rolled back.
Park and store bale probe points pointed against bale, building, or other stable object.
0595-3144 3145 IMPORTANT DECAL
Loader attachment cylinders must be pinned to correct hole or cylinder damage will occur voiding warranty.
35 Series 4WD, Model - 3535 & 4035 Loader June’08
