14
P
1. SPECIFICATIONS
Model ML120
Front End Loader
For Use with
Models
3 Cylinder 35 Series
Tractors
SPECIFICATIONS OF LOADER: ......................................................................................................................ML120
A.
Maximum Lift Height to Pivot Pin................................................................................................... 8’ 9" (105")
B.
Maximum Lift Height under Level Bucket ................................................................................ 8’ 4.5" (100.5")
C. Clearance
with
Bucket Fully Dumped ............................................................................................. 7’ 1" (85")
D.
Reach at Maximum Lift Height (to Grill Guard) ......................................................................... 2’ 1/2" (24.5")
E. Maximum
Dump Angle ..................................................................................................................40 degrees
F. Reach
with
Bucket on Ground............................................................................................................. 5’ (60”)
G. Maximum
Rollback Angle ..............................................................................................................19 degrees
H. Digging
Depth ........................................................................................................................................ 3 3/8"
J. Overall
Height
in Carry Position ................................................................................................ 4’ 8"* (55.6"*)
L. Bucket Depth ............................................................................................................................................. 21"
M. Bucket
Height ............................................................................................................................................ 20"
N.
Loader Bucket Pin to Front of Front Cutting Edge ................................................................................. 25.6"
P.
Loader Bucket Pin to Bottom of Front Cutting Edge .............................................................................. 4.48"
U.
Lift Capacity to Maximum Height at Pivot Pin.....................................................................................1960 lb.
Y.
Breakout Force at Ground Line at Pivot Pin.......................................................................................3900 lb.
*Top of Arm with Bucket 12" off ground.
Specifications taken with Ag. Tires (12-16.5 front and 16.9 x 24 rear) with 72” skid steer bucket installed
on unit.
Cycle time
1000 rpm
1500 rpm
2000 rpm
Full rpm
Raise time
10.1 sec.
7.7 sec.
6.1 sec.
4.9 sec.
Lower time
5.4 sec.
5.5 sec.
4.8 sec.
4.1 sec.
Dump time w/regen
5.5 sec.
4.5
sec.
4.2sec.
3.8
sec.
Rollback time
5.3 sec.
4.1 sec.
3.6 sec.
3 sec.
Lift Cylinder Dia. ..................................................................................................................... 2” x 1-1/4" Rod
Tilt
Cylinder Dia. ..................................................................................................................... 2" x 1-1/4” Rod
Relief
Valve
Setting
(Tractor relief) .................................................................................................... 2950 psi
Loader
Package Weight ........................................................................................................................1425#
Specifications taken with Mounting Kit, Hose Kit, and 72" Skid Steer Bucket.
Specifications based on ASAE standards S301.3 and furnished for general information only as they can vary with different tractor
models. Specifications are subject to change without notice and without liability therefore.
1.1. BUCKET SPECIFICATIONS
BUCKET CAPACITY
STRUCK CAPACITY
RATED SIZE CAPACITY
72” Skid Steer Bucket
12.5 cu. ft.
16.3 cu. ft
J
H
D
B
C
G
E
F
A
U
Y
35 Series 4WD, Model - 3535 & 4035 Loader June’08
