62
12.1.4. When Skid Steer Tool Carrier attachment is
aligned with bucket or attachment, raise loader boom
slowly making sure Skid Steer Tool Carrier vee
components engage. Then roll Skid Steer bucket or
attachment back slowly.
12.1.5. Position loader so attachment is approximately
1" off ground.
12.1.6. Position handles
into the handle engaged
position, rotate skid steer
tool carrier handle
downward until they latch
into position.
NOTE: Handles should
be positioned parallel to
ground if properly
latched.
Rotate handles
downward.
12.1.7. Check that bucket or attachment is securely
attached to Skid Steer Tool Carrier by raising loader
boom 3 to 4 feet, dumping bucket or attachment
against stops, and checking to be sure bottom of
bucket or attachment does not roll forward away
from Skid Steer Tool Carrier Assembly.
CAUTION: Do not allow anyone in loader work area, under raised loader, or to reach through the
loader boom when the loader is raised.
1”
35 Series 4WD, Model - 3535 & 4035 Loader June’08
