64
13. REMOVING BUCKET OR ATTACHMENT
FROM SKID STEER TOOL CARRIER
IMPORTANT: Refer to Pages 60 for instructions concerning Skid Steer Tool Carrier Handles Disengaged
and Engaged Positions.
CAUTION: Before leaving the tractor seat, stop the engine and lock brakes when installing or
removing bucket or attachment.
13.1. OPERATING INSTRUCTIONS
13.1.1. To disconnect bucket or attachment from
loader, position bucket or attachment slightly rolled
back and approximately 1" off of ground.
13.1.2. Position handles
into the handle disengaged
position by rotating skid
steer tool carrier handle
upward.
Rotate handles
upward
13.1.3. Roll bucket or attachment forward and lower to
ground. Back loader away from bucket or attachment.
NOTE: Over extension of tilt cylinders during this
operation could cause damage to Skid Steer Tool
Carrier handle due to handle contacting bucket or
attachment.
1”
35 Series 4WD, Model - 3535 & 4035 Loader June’08
