9 Prepare to Ride
9.2 Post-Ride Inspection Checklist
Always inspect and confirm your ROXOR and safety devices have
not been damaged after a ride. Always follow the maintenance
schedule described in this Operator’s Guide.
What to Do After Stopping the Engine
l
Clean the ROXOR and lubricate all moving parts.
l
Let drivetrain cool and then check fluid levels, top off as neces-
sary.
l
Inspect and remove all dirt and debris from your engine, trans-
mission, exhaust and other components that can get hot during
a ride.
l
Check for fluid leaks in the engine compartment and under
ROXOR.
l
Properly park the ROXOR on the flattest surface available.
l
Put gear shift lever in first gear and set parking brake by pushing
the button in, pulling straight up and then releasing button.
l
Remove the ignition key before leaving the ROXOR.
Verify that the ignition key is in the OFF position. If left
in the ACC position for extended periods of time electrical loads can
drain the battery and cause the vehicle to not start when needed.
24
© 2018 Mahindra Vehicle Sales and Service, Inc. All Rights Reserved.