© MAHLE
Operat ion | ACX118 0 | 21
ACX118 0 | 21
| 21
en
6.4
Aut om at ic A/ C ser vic e
m
Before connecting service hoses proceed as follows:
1. Perform refrigerant identification (if equipped - see
chapter 6.3).
m
Only after successful identification of refrigerant, service
hoses may begin on the vehicle. (If Ref. ID installed and
enabled).
t
The contamination of the ACX1180 internal bottle can
only be removed by a service provider at additional cost.
t
The service parameters (recharge quantity) can be found
in the owner's manual or the vehicle repair manual.
1. Turn unit on and once the first screen is loaded, press
YES to perform an Aut om at ic Cycle. (Or use quick
button at top of keypad.)
2. Select vehicle from A/C Capacity Guide (if installed and
equipped).
3. Follow the menu prompting.
4. Unit will perform Recycle, Vacuum, and Recharge.
t
All service phases can be implemented manually with
the ACX1180.
t
R134a can only be added to an air conditioning system
in which there is a vacuum. The vacuum phase must
therefore be implemented before filling with R134a.
6 .5 M anual
A/ C
ser vic e
m
Before connecting service hoses proceed as follows:
1. Perform refrigerant identification (if equipped - see
chapter 6.3).
m
Only after successful identification of refrigerant, serv-
ice hoses may be connected to the vehicle. (If Ref. ID
installed and enabled).
m
The contamination of the ACX1180 internal bottle can
only be removed by a service provider at additional cost.
t
The service parameters (recharge quantity) can be found
in the owner's manual or the vehicle repair manual.
1. Use or to scroll to desired service and press YES.
(or push one of the buttons at the top of the keypad.)
2. Follow the menu prompting.
t
All service phases can be implemented manually with
the ACX1180.
t
R134a can only be added to an air conditioning system
in which there is a vacuum. The vacuum phase must
therefore be implemented before filling with R134a.
