EN | 24 | AIR-NEX 9350/9450 | Cycles
© MAHLE
•
Oil Charge mode and quantity of
oil that will be charged into the
system
o
OIL: <value> g. It
charges the quantity of
oil that has been set.
o
REC. + <value> g. It
charges the quantity of
recovered oil plus the
quantity of oil that has
been set
o
NO OIL. No oil is
charged during the
charge cycle
•
Oil type: It sets the oil type being
used. PAG (ISO46/100/150) or
POE, it does depends by the
selected vehicle.
•
It is possible to select the charge
of the UV dye (a single shot of
about 8 g.)
•
amount of refrigerant that will be
charged into the system and the
amount of refrigerant available in
the inner tank of the station.
•
Charge type: It allows selecting
from which hose the service is
carried out, according to the
type of system.
o
Charge from HP hose
(red)
o
Charge from LP hose
(blue)
o
Charge from HP hose
(red) and LP hose (blue)
o
Charge from HP hose
(red) on the system low
pressure side. Specific
for some Renault
models.
At the end of the setup, press the “START”
button to start the automatic cycle.
11.4.1
Electric Compressor
Function
Before connecting the A/C service station
hoses to the A/C system of the vehicle,
select the oil type.
If the selected oil type is POE for Electric
compressor, a special function named
“Electric Compressor Function” will be
executed to clean the hoses from any
previous oil residue.
When required by the software, connect
LP and HP quick coupler to their support
connectors as in the picture below and
change PAG oil bottle with the POE oil
bottle.
Then, press START to proceed and follow
the instructions shown on the screen.
Summary of Contents for AIR-NEX 9350
Page 2: ......
Page 4: ...EN 2 AIR NEX 9350 9450 CONTENTS MAHLE 15 Spare parts 34...
