D O M E S T I C C O F F E E G R I N D E R S
GB
After you have set the grind adjustment to
the required level, press the corresponding
dosing memory button, and then START. The
coffee grinder starts, and the display (Pos.
17) counts downwards from the preset time.
The coffee grinder stops automatically
on reaching 0. To stop the coffee grinder
at any time during the grinding process,
simply press the START button again.
Depending on the required amount of
coffee, you can easily programme a longer
or shorter grinding time as follows:
1. To set the time, press the +/- buttons (Pos.
12/13) below the display. Press and hold
the respective button for three seconds in
order to advance or reduce the time more
quickly.
2. As soon as you have reached the required
time setting, press and hold the correspon-
ding dosing memory button (Espresso, Fil-
ter or Press) for 3 seconds. The time shown
in the display flashes in confirmation that
the setting has been saved.
3. Repeat steps 1 and 2 above for the other
two dosing memory buttons. The amount
of coffee you have to grind depends on the
type of bean, the fineness, the preparation
method and your personal taste. You will
soon find the settings most suitable for
your taste.
9. SLEEP / AUTOSLEEP
The coffee grinder has no power switch,
although it can be set to a sleep mode in
order to minimise the power consumption.
9.1 Sleep function:
The grinder is set to the sleep mode by
pressing and holding the START button
for 3 seconds. The sleep mode can be
deactivated by pressing any other button,
without activating the function of this
button.
9.2 Automatic sleep function (Autosleep):
If no button is pressed for 3 minutes, the
grinder switches automatically into the
Autosleep mode. Pressing any button
restores the grinder to the operating mode.
9.3 Setting the Autosleep mode:
The factory setting (3 minutes) can be
changed: To do this, press and hold the
MANUAL button for 5 seconds. The display
shows “S03”. The time at which the grinder
goes into the Autosleep mode can now
be set with the aid of the +/- buttons.
The available settings are 3, 5, 10, 20, 30
minutes and 0 (= no Autosleep). The setting
is saved by pressing the MANUAL button.
The programmed times for dosing also
remain saved in the Sleep mode or if the
plug is removed from the socket.
10. CARE AND CLEANING
Danger due to improper cleaning:
Improper cleaning can result
in damage to the appliance or
personal injury.
•
Only dismantle the coffee grinder in
accordance with the information given in
the Section “Care and cleaning”.
•
Watch out for sharp edges when cleaning
the coffee grinder, particularly on the
grinding discs. Danger of injury!
•
Never immerse the appliance itself, the
power supply cable or plug in water.
•
Never touch the plug with wet hands.
•
Never pull the plug out of the socket by
the cable, always grasp the plug.
•
Never attempt to touch or pick up and
electrical appliance if it has fallen into
water. In this case, disconnect the plug
from the socket immediately.
•
Check the appliance and cable regularly for
damage.
DANGER
21
