23
eK43 | eK43 S | en
Error
Cause
Remedy
The grinder is
not grinding or
buzzing.
•
The power plug
is not plugged
into a socket.
t
Insert the mains plug into a prop
-
erly installed wall socket.
•
The thermal
overcurrent
circuit-breaker
has been trig
-
gered.
t
Check whether the release button
has popped out.
Push it back in if necessary. If the
circuit-breaker repeatedly pops out,
contact your supplier (see chapter
“Maintenance and service”).
• The electrical
fuse has
tripped.
t
Check the electrical fuse. Bring it
back to its original state or replace
the electrical fuse.
Check whether other loads are
connected to this fuse and if so,
pull their plugs.
If the back-up fuse trips repeatedly,
contact your supplier (see chapter
“Maintenance and service”).
The grinder is
not grinding
fine enough.
• The grinding
discs are worn
out.
t
Contact your supplier (see chapter
“Maintenance and service”).
• The grinding
discs are not
aligned cor
-
rectly.
t
Contact your supplier (see chapter
“Maintenance and service”).
Summary of Contents for EK43 S
