2
Mahr GmbH • Multimar 844 S
Dear customer,
Thank you for choosing a product by Mahr GmbH. We kindly request that you follow the
instructions below to ensure the long-term precision of your instrument.
We operate a policy of continuous improvement and are constantly developing our products.
Therefore, it is possible that there may be slight differences between the text and illustrations
in this document and the instrument in your possession, especially with regard to type
designations. We reserve the right to make changes to the design and scope of supply, the
right to undertake further technical developments, and all rights relating to translation of this
documentation.
© by Mahr GmbH, Esslingen, Germany
The following symbols are used in these operating instructions:
General information
Caution
Caution, hazard
Failure to follow instructions marked with this symbol may lead to inaccurate results
and cause damage to equipment.
1. Introduction
Intended use
The 844 S setting instrument is used to adjust the length measurements in production, quality
control and in the workshop.
Intended use is subject to compliance with all published information relating to this product.
Any other use is not in accordance with the intended use. The manufacturer accepts no liability
for damages resulting from improper use. All statutory and other regulations and guidelines
applicable to the area of use must be observed.
The operating, maintenance and repair information detailed in these operating instructions
must be followed.
To get the most out of this measuring instrument, you should read the operating instructions
prior to commissioning the instrument.
2. Delivery of the 844 S setting instrument includes:
- Light alloy bar with gage block holder
- Operating instructions
!
