15 Dismantling
50
Large pack of ZF EC+ replacement air filters
for ER-A
Article no. 0093.0611
• 100x ZF EC+ replacement air filters (filter class
G2)
• 100x filter change indicator (TimeStrip)
ZF EC replacement air filter for ER-AH ER-AK
ER-AB
Article no.
0093.0758
• 5x
ZF EC
replacement air filters (filter class G2)
Large pack of ZF EC replacement air filters for
ER-AK, ER-AH and ER-AB
Article no. 0093.0759
• 100x ZF EC replacement air filters (filter class
G2)
ZRF replacement air filter for ER-ZR second
room connection set
Article no. 0093.0923
• 5x replacement air filters for internal grille ER-
ZR second room extraction (filter class G2)
ZF ECD replacement permanent filter for ER-
AK, ER-AH and ER-AB
Article no. 0093.1561
• 2x replacement permanent filters for covers of
the ER EC fan unit (filter class G2)
ZF ECD+ replacement permanent filter for ER-
A
Article no. 0093.1562
• 2x replacement permanent filters for covers of
ER EC fan unit (filter class G2)
• 10x filter change indicator (TimeStrip)
15 Dismantling
Dismantling may only be undertaken by a
qualified electrician: Specialist installer qualifica-
tions [
1. Before accessing the connection terminals,
shut down all supply circuits (switch off mains
fuse), secure against being accidentally
switched back on and position a visible warn-
ing sign.
2. Remove fan insert.
3. Remove all cables.
4. Remove flush-mounted housing from wall.
16 Environmentally responsible
disposal
Old devices and electronic components may
only be dismantled by specialists with elec-
trical training.
Proper disposal avoids detri-
mental impact on people and the environment
and allows valuable raw materials to be reused
with the least amount of environmental impact.
Do not dispose of the following
components in household waste!
Old devices, wearing parts (e.g. air fil-
ter), defective components, electrical
and electronic scrap, environmentally
hazardous liquids/oils, etc. Dispose of
them in an environmentally friendly
manner and recycle them at the ap-
propriate collection points (→ Waste
Management Act).
1. Separate the components according to mater-
ial groups.
2. Dispose of packaging materials (cardboard,
filling materials, plastics) via appropriate re-
cycling systems or recycling centres.
3. Observe the respective country-specific and
local regulations.
Acknowledgements
©
Maico Elektroapparate-Fabrik GmbH
. Trans-
lation of the original operating instructions. Mis-
prints, errors and technical changes are reserved.
The brands, brand names and protected trade
marks that are referred to in this document refer
to their owners or their products.
