Maico PP 45 RS, Installation Instructions Manual

6 Installation

8

off protruding construction foam and shims
flush with the masonry block. 

ATTENTION:

 Note the gradient. Building dam-

age due to condensation if installed incorrectly.

 Information on PP 45 and PPB 30 units

•

PP 45:

 Use the recess shown in the figure to

feed the connection cable. This is positioned in
the 

PP 45

 unit to match the line feedthrough.

•

PPB-30:

 Feed the connection cable outside the

masonry block.

6.2 Installation of PP 45 RS

PP 45 RS: Minimum distances to the wall and
ceiling

Projection of the wall sleeve (on delivery) for
internal and external covers

• inside 12 mm

• outside 40 mm

Minimum distances for PP 45 units

Minimum distances for PPB 30 units

Shortening the PP 45 RS

1. Shorten the 

PP 45 RS

on the outside

 in the

area between the cutting marks to the appro-
priate size. Use a saw suitable for EPS. Ob-
serve the markings for the wall thicknesses

 Only saw PP 45 RS carefully, all the way

round to the wall sleeve! Do not saw the wall
sleeve. Remove sawn-off EPS polystyrene
parts.

Shorten wall sleeve.

1. Shorten and deburr the wall sleeve according

to the wall thickness. Take into account the re-
quired wall sleeve projections for plaster, ma-
sonry, internal and external cover.

 Wall sleeve projections

•

Shorten

 the wall sleeve 

on the outside

. Ob-

serve the 

prescribed

 wall sleeve projection for

the respective external cover.