INSTRUCTION MANUAL FOR DISHWASHERS
Page 3 of 14
UK
NEVER
place your bare hands in the wash solution.
NEVER
overturn the machine after it has been installed.
If you notice any malfunction or fluid leak, immediately disconnect the power
supply and shut off the water supply.
Do not install the dishwasher in the vicinity of heat sources over 50°C.
NEVER
leave the dishwasher exposed to the weather (rain, direct sunlight,
etc.)
The dishwasher may not be installed outdoors without proper cover.
Never start a wash programme without the overflow in the tub, as applicable.
Never place magnetic objects in the vicinity of the machine.
Do not use the top of the machine as a table or support.
The installer is responsible for checking that the grounding system is fully
operational.
At the end of testing, the installer must issue a written declaration stating that
the machine has been installed and tested in accordance with established
legislation and good practice.
DO NOT
change the position or tamper with the elements of the machine, as
this could compromise the machine safety.
Noise pressure level according to EN ISO 4871
o
LpA Max = 55db Kpa=2.5db for undercounter versions
o
LpA Max = 65db Kpa=2.5db for hood versions
o
LpA Max = 76db Kpa=1.5db for utensil washer versions
Max inlet water temperature: 50°C
Max inlet water pressure: 4bar (400kPa)
Appliance designed for permanent connection to the water supply
Do not clean the appliance with steam or water jets.
Max loading height
o
On the ground in the versions with overflow
o
Maximum height 1 m in versions with discharge pump
1.1
Normal operating conditions
Ambient temperature: 40°Cmax /4°Cmin (average 30°C)
Altitude : up to 2000 metres
Relative humidity : Max 30% at 40°C / max 90% at 20°C
