Installation
IDM 510-019-6
10
English language
Installation manual
3°
13.
Attach the column
H
to a lifting
device.
14.
Lift the column
H
to its vertical
position.
Attention
Warning
Keep reel holding carriage con-
veying belt tensioned until col
-
umn H is in vertical position.
Do not remove the locking de-
vices of reel holding carriage
until column H is in vertical po-
sition.
15.
Tighten screws
E
.
16.
Remove support
A
.
17.
Tighten the screws
F
on both
sides.
Attention
Warning
Check that in column base H
electric or pneumatic cables are
not crushed and that there is no
interference with machine or ex-
ternal elements.
18.
Remove the lifting device.
4°
19.
To reach high, not easily acces-
sible or otherwise hazardous
areas, implement adequate
safety measures to avoid risks.
20.
Assemble the guard
M
and fix it
with the screws.
21.
Pull handle
N
and fix it to fastening pin
P
with one of the available holes.
22.
Install the wheel
Q
of the feeler and lock it with the screw
R
.
23.
Tighten knob
S
.
24.
Carry out the acceptance inspection in order to check the proper machine func
-
tionality.
Accumulator batteries are installed as already ready for use (charged).
In case of shipment by air, the machine is delivered with non-installed batter
-
ies.
Upon receipt, disassemble panel and install batteries (See
Check the battery conditions and capacity and, if necessary, recharge it.
25.
At the end of operations check that there are no other tools or other material near
the moving parts or in dangerous areas.
