10
Filling
Filling an APEX open loop system
•
Remove the right fitting on the top of the APEX block. ...Ref 8
•
Pour coolant into a squeeze bottle
•
Insert nozzle of squeeze bottle into the opening where the
fitting was removed from and gently squeeze the bottle to
refill the loop. Ensure not to apply too much pressure as
splash back is possible
•
Fill the loop and leave about a quarter of an inch and replace
the fitting that was removed, ensuring it is hand tightened
fully.
REMEMBER THAT IF ANY LIQUID MAKES CONTACT WITH ANY
COMPONENT TO ALLOW THE SYSTEM TO DRY FOR ATLEAST A
DAY BEFORE POWERING IT BACK ON.
