TROUBLE SHOOTING
Please note that the winder is designed to rotate and maintain the amount of
power reserve in the watch. If your watch is already on a low amount of
power reserve or is not running when you place it in the winder, it may not
work.
Please check that the door of the winder is closed. The winder motors will
stop running when the door is open when the “SELF STOP SWITCH” is
operated.
There are some factors which generally affect the effectiveness of the
winder :
1. Check the watch placement in the winder. Your watch should be placed
in the winder with the dial facing you. When looking at your watch in
the winder, it should be as if you are making a reading of it from your
wrist.
2. Some watches must be fully wound before being placed into the winder
as the power reserve when removed from your wrist may not be enough
to keep the watch wound. Please refer to your instruction manual on how
to manually wind your watch.
3. Manually wind your watch prior to placing it into the winder.
You can prop the back of the winder using a book or magazine to
increase the angel of the turntable and test the winder again. The closer
the watch dial is to being vertical the better the chance of the test being
accurate.
CAUTION:
1. Please use the adapter included with your watch winder or similar
adapters with the exact same voltage output.
2. Please do not manually spin the winder. This will damage your watch
winder and void your warranty.
3. Avoid exposing the watch winder to direct sun, water and extreme
temperatures which may damage the watch winder.
6
