Pg 12 of 24
1-800-892-3986
IS9555
Step 11 - Mounting the unit to the wall.
RECOMMEND
WARNING:
BEFORE CUTTING OR DRILLING INTO ANY WALL SURFACE, VERIFY THE LOCATION OF ELECTRICAL,
PLUMBING AND GAS LINES. CUTTING ANY OF THESE MAY CAUSE SERIOUS INJURY.
• It is imperative that the unit be fastened to the wall for safety and stability.
1/4 in. drill bit
for drywall anchor
OR
1/8 in. drill bit
for direct stud
• Using a drill and a small drill bit, drill a hole through the hole in the angle block (H13) and through back panel.
• Place unit in desired location on wall and mark hole locations on wall.
• Drill holes in marked spots on wall and insert drywall anchors (H16).
NOTE: A drywall anchor is not necessary
if the mounting screw will be screwed directly into a stud.
•
Mount unit to wall, using mounting screws (H15).
Mounting Screw (H15)
Drywall Anchors (H16)
Wall Mount Kit
angle blocks (H13)
H 15
H 13
