MP3900X Series Router Installation Manual
Router Installation
copyright
©
2020 Maipu, all rights reserved
3-9
Figure 3-4 Install the router to the standard cabinet
1. Load bearing tray
2. Cabinet square hole column
3. Device host
⚫
If the screw hole on the hanging ear cannot align to the floating nut installed on the
cabinet correctly, check whether the bearing surface of the slide (tray) is on the
integer U boundary and whether the floating nut is installed on the correct hole
position.
⚫
In some special installation environments, if it is necessary to install the device in
reverse direction (the rear panel of the device is facing the front door of the cabinet),
remove the hanging ears on both sides of the front panel of the device with a
screwdriver, and install on both sides of the rear panel of the device before installing
device on the cabinet.
Step 2: Use the M6 panel screws to fix the floating nuts on the chassis mounting ears and
cabinet post square hole bar, so as to prevent the router from sliding front and back.
