S3100 Install Manual (For SM3100-28TC-AC and SM3100-52TC-AC) V4
.0
z
Use electromagnetic shielding if necessary.
R a c k C o n f i g u r a t i o n
The switch size fits the standard 19’’ rack. Pay attention to the following
instructions to ensure a good ventilation and air circulation:
z
All devices on the rack will generate heat during their operation,
therefore vents and fans are required for an enclosed rack. Keep
devices at a certain distance from each other to ensure a good
ventilation and air circulation.
z
For an open rack, make sure not to block the vents on both sides of
the switch by carefully checking the switch status after its installation.
Caution
Put the switch on a stable and clean desktop as a substitute of a standard
19’’ rack, leaving a space of 10mm around the switch for ventilation. And
don’t place anything on top of it.
Installation Instructions
z
Read related chapters in this manual carefully or participate in
concerning technology training before the installation. Make sure all
materials, tools and other items required by the installation are
prepared, as well as a proper site for installation and debugging.
z
During the installation, it is required to use the brackets and screws
provided in the accessory kit, and proper tools to ensure stability and
reliability. Users should always wear antistatic uniforms and ESD wrist
straps to prevent damaging the switch, and should only use and make
standard cables and connecters. Be cautious to potential dangers
during the installation, and make protective preparations to avoid
accidents.
z
Clean the site after the installation. Please ensure the switch is well
grounded before powering it on. Users should also maintain the switch
regularly to extend its lifespan.
Security Warnings
z
Do not stare directly at the fiber port during operation to prevent eye
damage caused by the laser transceiver in the SFP optical module of
the switch,
Maipu Confidential & Proprietary Information
Page
15
of
19
