S3100 Install Manual (For SM3100-28TC-AC and SM3100-52TC-AC) V4
.0
The brackets are used to fix the switch on the rack rather than bearing its
weight, so it is recommended to place a rack shelf under the switch. Do
not place anything on top of the switch or block the vents, to prevent
device damages and abnormal operation.
Console Cable Connection
MyPower S3100 Intelligent Stackable Secure Ethernet Access Switch
provides a DB9 asynchronous interface serial console port. The connection
procedure is listed below:
Figure 2-2 Connecting Console port to MyPower S3100 switch
1.
Attach the console cable provided in the accessory kit to console port
of the switch.
2.
Connect the other side of the console cable to a character terminal
(PC).
3.
After powering on the switch and the character terminal, configure the
switch through the character terminal.
Caution
Please use the console cable and the console commutator of the switch.
Don’t insert it to other ports or insert other cables in the Console port, to
prevent damaging the cable and the port.
Power Cable Connection
The power of MyPower S3100 Intelligent Stackable Secure Ethernet Access
Switch is 100~240VAC, 50~60Hz, allowing a certain extent of voltage
fluctuation. Please connect the power cable following the steps below:
Maipu Confidential & Proprietary Information
Page
18
of
19
