Page 6 of 17
2 Getting Started
2.1 Inserting the Memory Card
Insert the memory card with the gold contacts facing the back of the camcorder. Push the
memory card until it clicks into place.
To remove the memory card
Push to eject the memory card out of the slot.
Note:
1. Do not remove or insert the memory card when the camcorder is turned on. This may
damage the memory card.
2. It is recommended to use a 32GB, Class 10 or above micro SD card.
3. Please format the micro SD card prior to the initial use.
4. If the screen shows “Low Speed Card” while recording, it means the writing speed of the
memory card is too slow. Please replace it with a higher-speed memory card.
2.2 Camcorder on/off
2.2.1 Auto On/Off: the device will automatically turn on when the car engine starts up, and
automatically start recording when the camcorder turns on. Once the engine stopped, the
device will automatically save the recording and turn off (Please set <Delay Power Off> to 15s,
see Page 11).
2.2.2
Manual On/Off: long press the power button to turn on/off the camcorder.
2.3 Set date and time prior to use
2.3.1 The device will automatically start recording when turns on, please press the
REC
button
to stop recording and enter Standby Mode.
2.3.2 Press the
Menu
button once to enter Recording
setting, press ▼ button to select <Time
Zone>, press
REC
button to enter time zone setting, press
▲
or
▼ to set the time zone to <+0>
for UK, Press
REC
button to confirm.
2.3.3 From Standby Mode, press
Menu
button twice to enter system setting,
press ▼ button to
select <Time Setup>, press
REC
button to enter time setting.
Press the ▲or▼ button to adjust
the value of date/time, press the
REC
button to
enter another field. Press
REC
button to
confirm the value and press
Menu
button to exit.
