1.
Signals were transmitted by laser through optical fiber. The laser meets the
requirement of class I, no harm with normal operation. Do not look directly into the
fiber port and the end of the optical fiber terminator.
2.
Dust plugs need to be installed when optical connectors and optical modules are
not in use. Dust caps need to be installed when optical fibers are not in use.
3.
The bending radius of optical fiber should be greater than 20 times the diameter of
the optical fiber. In general, the bending radius should be equal to or greater than
40mm.
1.
When using a switch, the voltage can only be input from V1+ and V1-, V1+ connects
to live wire L, and V1- to neutral wire N. Do not connect from V2+, V2-; pay attention
to safety and prevent electric shock.
2.
Power-on operation: First connect the power cord to the power terminal of the
device according to the definition shown in the figure above, and then power on.
3.
Power-off operation: first unplug the power plug, and then remove the power cord.
Warning
Power input
Before connecting the power cord, make sure that the ground is connected. Do
connect the power cord to the power terminal of the device according to the definition.
Notes
MIEN2208-F
MIEN2208-2F
MIEN2208-4F
Switch performance
Backplane bandwidth
1.6G
Cache size
768Kbit
MAC address
2K
Interface
100Base-FX port
1*100Base-FX
2*100Base-FX
4*100Base-FX
Connector SC/FC/ST optional
100Base-TX port
7*10 /100Base-TX
RJ45 ports
6*10 /100Base-TX
RJ45 ports
4*10/100Base-TX
RJ45 ports
With adaptive function, support MDI/MDI-X connection
Power
Power consumption
<5W@24V full load
DC input
Support dual DC12~48V or DC48V (36-72V) power supply
AC input
AC85~264V (frequency: 47~63Hz) or DC110~370V
Mechanical
Size
138mm×54mm×110mm(H×W×D)(Excluding DIN rail)
Installation method
35mm standard DIN rail installation
Heat dissipation form
Aluminum alloy single-rib chassis surface heat dissipation, no
fan.
Weight
About 0.67kg
IP protection
IP40
Working environment
Operating temp.
-40
～
+85
℃
Storage temp.
-40
～
+85
℃
Humidity
5
～
95% (No condensation)
Industry standard
EMC
IEC61000-4-2(ESD), Level4
IEC61000-4-5(Surge), Level4
IEC61000-4-4(EFT), Level4
Specifications
