MIEN3024/3026 Rack Mount Industrial Ethernet Switch
- 12 -
PING command examples:
The IP address of computer 1 is 192.168.0.10, and the IP address of
computer 2 is 192.168.0.11. Make sure that the first item "Allow incoming echo
requests" in the ICMP settings of the local connection of the firewall of the two
machines is checked.The operation method is to open the windows protection
in the advanced page of firewall settings, set the ICMP protocol, as shown in
Figure 2-16 below
.
Figure 2-16 ICMP setting interface diagram
Then click Start→Run of Computer 1, and enter cmd or command (cmd
for Win2000/XP system, WIN98/95 the system uses the command) command
to pop up the console window and send ping 192.168.0.11 -l 1000 -t, (-l refers
to the word for sending data packets the number of sections, -t means sending
data continuously), run ping 192.168.0.10 -l 1000 -t in the computer 2 in the
same way. If computer 1 returns Reply from 192.168.0.11: bytes=1000
time<10ms TTL=128, computer 2 returns reply from192.168.0.10: bytes=1000
time<10ms TTL=128, after running for more than 10 minutes, use the CTL+C
command to calculate the packet loss rate as 0,the device is working properly.
As shown in Figure 2-17 below.
Figure 2-17 The result of testing inputting ping computer in CMD
