MISCOM7028GX/MISCOM8028GX Series Industrial Ethernet Switch
- 8 -
pair), the TX port is the fiber transmitting end, connecting with the fiber
receiving end RX of the other remote switch FX port. The RX port is the fiber
receiving end, connecting with the fiber transmitting end TX of the other remote
switch FX port. Two redundant 1000Base-LX FX ports can be used to establish
a fiber redundant ring network. If system fails, the ring network redundancy
recovery time is less than 20ms, which can effectively improve the reliability of
network operation.
SFP module as below picture.
SFP module
2.4. CONSOLE Port
CONSOLE port
is a RJ45 port, refer to below diagram. Please use
MAIWE brand serial extension cable to connect with PC serial port. It is a
standard 3 wire RS-232 cable.
Serial port communication parameters are as follows:
Baud Rate: 115200; Data Bits: 8; Parity: None; Stop Bit: 1; Flow Control:
None.
RJ45 serial port diagram
2.5. Relay Port
The terminal blocks of the series of switches’ power failure alarm relay use
3-bit 5.08mm pitch terminal, please refer to below diagram. The alarm relay’s