Memory query
(1) when the thermometer is on, press "up" or "down" to view the memory record
(2) counter after "memory" in the bottom left corner of the screen.The count goes from 1 to 32, and the counter
increases by 1 for each valid measurement, and then returns 1 again after 32
(3) historical data review.After each test, the instrument will automatically record the test data, up to 32
historical test data can be recorded, press "up" or "down" key.
9. Routine maintenance
The probe part is the most precise part of the product and must be carefully protected. Wipe the surface of the
meter with 70% alcohol cotton. Do not use aggressive cleaners
Never immerse the product in water or other liquids.
Keep this product in a dry place to avoid dust, pollution and direct sunlight.
10. Troubleshooting
If you encounter the following problems during use, please follow the instructions in the maintenance
instructions to find a solution. If the problem persists, please contact our customer service.
LCD cannot display the value
If it is lower than 32
℃
or higher than 42.5
℃
in the anthropometric state, the LCD will not display data, but will
display "LO" or "HI". LCD display message "HI"
Using a non-contact infrared forehead thermometer, the HI analysis of the LCD display shows that the human
body temperature is higher than 42.5
°C
.
LCD display message "LO"
Using non-contact infrared forehead temperature timer, LCD display information Lo analysis table when body
temperature is below 32
°C
(4) Press and hold the “down”button for 3 seconds to select the Temp model between Centigrade and
Fahrenheit degree.
