Tel44 (0) 8448 001 500
Fac44 (0) 1279 635 074
info@majesticshowers.com www.majesticshowers.com
The Majestic Shower Company Limited
17 Flitch Industrial Estate, Chelmsford Road,
Dunmow, CM6 1XJ
Mark the screw holes for the hinges; remove the door.
5
Drill 7mm holes where marked on the wall; insert Rawl plugs.
Using the suction glass lifters, place the glass door complete
with hinges onto the mounting blocks.
Using only the four outer screw holes, tightly screw the hinges
to the wall. To prevent damage to the hinge plates, open the
door outwards to gain access to the inner screw holes; insert
screws and tighten fully.
One 1929 door-to-wall seal (1) should be cut
7
into three pieces to fit vertically above,
between and below the hinges on the end of
the door. With the door still open outwards,
slide the sections into place on the door.
The other 1929 door-to-wall seal should be cut to fit on the
exposed vertical edge of the glass door.
Close the door carefully and check the seal closes onto the
wall correctly. If necessary, the door can be adjusted on its
hinges; make sure the glass does not protrude past the hinge
plates into the hinge.
6
8
