Majestic ONE AT, User Manual

19

18

d) 

pull off the PU wheel. 

Due to the fitting of the parts, you need to pull off the drive wheel using 

more strength. Relax - nothing will go wrong ;) 

1) Only the wheel has been pulled off - leave the rack in place and press 

the PU wheel with bearings on top of the set. (go to point "e" and 
then "g")

2) The wheel has been pulled off along with the gear:

• the large bearing remains in the rack - leave it in place
• the large bearing is located on the hanger bushing - leave it in place
• remove the gear manually and then press it into the new PU wheel.

e)  put a PU wheel with a sprocket and a large bearing on it on the hanger's 

axis.

f) 

hit the wheel lightly with your hand until it clicks into place. If it does not 
fully fit, it will after tightening the nut on the axle.

g)  put the drive belt on the wheel sprocket and engine sprocket. Do not 

unscrew the engine. Attach the strap in the same way as you attach a 
bike chain. The belt should not be too tight or loose. The wheel must 

rotate easily while driving it with the remote control.

h)  put the distance washer on the hanger's axis. 

i)  screw the nut so that the wheel does not slack and rotates freely on the 

axis. If the wheel isn't in the proper position yet, tighten the nut until 
everything fits. After fitting unscrew the nut slightly so that the wheel 

can rotate freely.

j) 

fasten the engine rack cover using the included key. 

Before driving, make sure that all wheel bolts are located in the right place.

Warning

1.  Do not use polyurethane wheels for paving stones surfaces, for this type 

of surface always use off-road (AT) wheels.

2. 

Storing the wheels above 40 °C may cause them to be distorted. 

Distorted wheels stored above the permitted temperature are not cove

-

red by the warranty.

3. 

Off-road wheels should be pumped up to a maximum 

of 2,5 atmospheres.

4.  When replacing wheels with AT on PU and PU on AT, replace  

the self-locking nuts fixing the wheels on the hanger's axis or use 

an anaerobic adhesive to safely tighten the wheels.

SPECIFICATION