7
RFSUV34 Vent-Free Heater
Fig. 3
wall receptacle.
4. SLIDE THE HEATER IN PLACE
With the fan installed, gently slide or lift the
heater to the desired location.
5. LEVEL AND SECURE THE HEATER
Make sure heater is level. Shimming may be
required.
6. WINDOW FRAME REMOVAL (Fig. 4)
1. Shut off gas. (See Lighting Instructions)
2. Let the unit cool if it has been operating.
3. Open two side doors.
4. Open the clamps on two sides.
5. Pull the frame forward.
6. To reinstall window frame follow the above
procedure in reverse.
TOP VIEW
Valve
Fan speed
control/
Junction
box
Thermal sensor
location
Fan is
installed at
the back
of the
pedestal
Stud
Fig. 5. Log locations.
RFSUV34
KR7
KR8
KR10
KR9
No lava rock is to be placed on the
rear section of the burner.
PULL
THE
FRAME
FORWARD
OPEN
CLAMPS
7. LOG INSTALLATION (Fig. 5)
1. Remove window frame. (See "Window Frame"
section)
2. Remove logs from packaging.
As with all plastic - these are not
toys and should be kept away from
children and infants.
3. Place rear log (KR10) on rear bracket (ensure
log is seated properly, leveled and centered to
the unit), so it will not move from side to side
and it is firmly positioned on the bracket.
4. Slip front ember log (KR7) down behind the
front deflector.
5. Place front left log (KR8) on top of burner, left
side. Use log's bottom holes to locate it into
the left bracket log locator studs.
6. Place front right log (KR9) on top of burner,
right side. Use log's bototm holes to locate it
into the right bracket log locator studs.
7. Place burner lava rock on top of burner. (See
next section and picture for proper location)
8. Place top left log (KR11) onto locator notches.
Ensure log is secure.
9. Place top right log (KR12) onto locator
notches. Ensure log is secure.
8. BURNER LAVA ROCK PLACEMENT
Open the lava rock bag and place the contents
according to Figure 6. First place the small lava
rock, then the skinnnier and long sticks.
KR11
KR12
Fig. 4
