The Majestic Shower Company Limited
Two North Place, Edinburgh Way, Harlow, Essex CM20 2SL England
Tel44 (0) 8448 001 500
Fac44 (0) 1279 635 074 info@majesticshowers.com www.majesticshowers.com
9
13
14
Rio Installation Guide - Surface Profiles
Insert short pieces of the self adhesive rubber strip supplied in each In Line panel hinge slot
as shown to ensure that the door does not drop under its own weight over time.
Disassemble the hinges, being careful not to damage the polished surfaces, and place the
hinges and their face plates either side of the hinge slots on the In Line panel with screws
facing inwards. Ensure that each face of the glass is separated from the hinges by a gasket.
Loosely screw the hinges and face plates together.
DOOR
Rubber
strips
Position the hinges centrally in their slots and use a set square to align them with
the edge of the glass. Check that the holes are adequately packed with the rubber
strips by using a set square to ensure that the hinges are at 90 degrees to the
edge of the glass when upward pressure is applied to them.
Fully tighten the hinge screws on the In Line panel to 10-12 NM torque.
.
IN LINE PANEL
Hinge with face
plates removed
for illustration
purposes only.
Rubber
packing
strips
