3
Majestic • CKRUBY30, CKRUBY35 Contemporary Kit Instructions • 2542-939 Rev. B • 2/19
Figure 4. Stone Jig in Place
WARNING
Risk of Asphyxiation or Fumes.
• Place media according to instructions.
• Do NOT place media in area between glass and
firebox.
• Do NOT place media in a position that they may
fall into area between glass and firebox.
• Do NOT use any media other than the media
supplied with this fireplace.
Fireplace will not function properly.
Gas leak may occur.
WARNING
Delayed Ignition Risk
• Place media according to instructions.
• Do NOT place media in a position that they may
fall into area in front of pilot.
• Do NOT use any media other than the media
supplied with this fireplace.
• Do NOT exceed one layer of media on base pan.
Fireplace will not function properly.
Delayed ignition may occur.
12. If installing a stone kit, refer to the instructions in
the next section.
13 Remove rock stop.
Consumer:
Retain rock stop for future maintenance
or service needs.
14. Reinstall seal plate, glass assembly and decorative
front.
15. Re-connect electrical supply and turn on gas.
Service Parts
MODEL
DESCRIPTION
PART NUMBER
CKRUBY30
Burner Assembly
2535-007
Exhaust Baffle
2535-138
Base Pan
2542-131
CKRUBY35
Burner Assembly
2536-007
Exhaust Baffle
2536-138
Base Pan
2544-131
Insulation Board
2536-158
BOTH
Rock Stop Assembly
2535-197
Stone Placement Jig
2542-198
Pilot Shield
2535-120
Note:
A tall, deep orange flame should be avoided; this
type of flame may cause increased soot residue. If this
type of flame is noticed, try adjusting the media directly
beneath the flame. If all flames appear to be tall and deep
orange in color, then open the primary air shutter.
Please contact your Majestic dealer with any questions
or concerns.
For the location of your nearest Majestic dealer,
please visit www.majesticproducts.com.
Majestic, a brand of Hearth & Home Technologies
7571 215th Street West, Lakeville, MN 55044
www.majesticproducts.com
Installing Stone Kit
NOTE: Rock Stop Jig must be in place to install
stones.
1. Place stone jig on glass media with “STONE JIG” fac-
ing up. Ensure that the stone jig sits flush against the
rock stop. See Figure 4.
2. Place stones in a random manner in the open spots on
the base pan.
3. Remove stone jig and then the rock stop.
Consumer:
Retain both stone jig and rock stop for
future maintenance or service needs.
Figure 3. Glass Media Installed
WARNING!
Glass seal plate must be properly installed
Risk of elevated component temps and carbon monox-
ide exposure.
ROCK STOP
REAR MEDIA LEDGE
ROCK STOP
STONE JIG
STONES