Pencil lines showing the center line of the
jamb and the height of the bolt when locked
have been established. Use the alignment
marks on the template to align with the pencil
lines on the jamb. We will route the strike
opening with our HIT-40AR3 template. Attach
to jamb with the supplied tek point screws
and an electric drill. NOTE: It is a good idea
that your drill is equipped with a clutch
feature, this will prevent snapping the screw
off in the jamb.
Make sure the template is square to the jamb
prior to running the second screw in.
Template mounted and ready to go.
Copyright 2007—Major Manufacturing
Page 5
