With both clamps opened equally,
install both inside and outside
templates to the HIT-66 clamp as
shown. Do not tighten the 10-32
screws at this time. When all screws
have been loosely installed, then it is
ok to tighten.
Install the alignment guide to
either side of the template
set. This is used to align the
template with the mortise
pocket.
Shown is a standard
mortise pocket, we will
use this as a basis for
the Falcon Mortise Lock
install.
PAGE 3
NOTE: The HIT-66 clamps
shown are not part of the
HIT-66-282 template set and
must be purchased as a
separate item.
