This is the HIT-45 clamp that will be used to install a
mortise lock. It can be used to install a variety of
hardware using interchangeable templates.
There is a backset stud located in the center of the top
and bottom clamp. It will set the correct backset
calculated from the center of the door regardless of door
bevel.
NOTE: IF YOU HAVE USED THIS CLAMP TO ROUTE
THE FACEPLATE—BE SURE TO REMOVE THE
BEVEL BLOCKS, FAILURE TO DO SO WILL RESULT
IN A MIS-DRILLED DOOR.
When attaching the mortise lock template to the clamp,
be sure the center hole of the template is fastened to the
center hole of the clamp.
Copyright 2008—Major Manufacturing
