ANUFACTURING, INC. (714) 772-5202 FAX (714) 772-2302
BALDWIN MORTISE LOCK
HIT-45BH1 TEMPLATE GUIDE
FOR USE WITH TRIM AS INSTALLED WITH BALDWIN SUPPLIED PAPER TEMPLATE FORM #PK-1076B (6-93)
EXCLUDING MORTISE LOCK SERIES 8550, 8555 AND 8560. REFER TO BALDWIN SUPPLIED BLUE INSTALLATION TEMPLATE
GUIDE CHART FORM #PK-1076C (10-93) TO DERTERMINE HOLE PATTERN TO DRILL ON DOOR.
USE MARKED HOLES AS FOLLOWS:
1) FOR ESCUTCHEON TRIM
Drill only if using escutcheon trim.
Template hole size: 1/4”, drill half way from both sides of door.
Enlarge hole to 1/2” after all other holes are drilled and HIT-45 clamp
Has been removed from door.
(2) FOR MORTISE CYLINDER
Drill only on side of door that has a mortise cylinder.
Template hole size: 1/4”, drill only to mortise pocket.
Enlarge hole to 1-1/4” with a hole saw.
(3) FOR TURN-KNOB
Drill only on side of door with a turn knob.
Template hole size: 1/4”, drill only to mortise pocket.
Enlarge hole to 5/8” with a hole saw.
(4) FOR KNOB OR LEVER SPINDLE
Drill to mortise pocket from both sides of door.
Template hole size: 1/4”.
Enlarge to 3/4” with a hole saw.
(5) THUMB PIECE HOLE
Drill only on side of door with a thumb piece.
Template hole size: 1/4”.
Enlarge to 1” with a hole saw.
CONTINUTED……...
VISIT OUR WEBSITE!
NOTE: THIS TEMPLATE WIL DRILL HOLES AT FOUR DIFFERNET BACKSETS. BE SURE TO CHECK THE BACKSET OF
THE LOCK YOU ARE INSTALLING. WHEN CHANGING THE TEMPLATE FROM ONE SIDE OF THE DOOR TO THE OTHER BE
SURE TO USE SAME BACKSET AS USED ON THE OTHER SIDE. FAILURE TO DO SO WILL RESULT IN A MISDRILLED
DOOR. THE HOLES USED TO ATTACH BACKSETS 1-1/2” AND 2-1/2” ARE NOT ALL LOCATED IN A STRAIGHT LINE ON THE
TEMPLATE. THEY ARE OFFSET AND USE THE TWO BOTTOM HOLES OF THE HIT-45 CLAMP. ALL BACKSETS ARE
MARKED AND LINES CONNECT THE CORRECT HOLES TO USE.
ALWAYS WEAR EYE AND EAR PROTECTION WHEN USING POWER TOOLS!
IMPORTANT: If using HIT-45 Clamp for faceplate routing you must remove
bevel blocks prior to drilling function holes. Failure to do so will result in
incorrect backset.
