USE MARKED HOLES AS FOLLOWS:
A. FOR KNOB OR LEVER SPINDLE HOLE
.
Drill to mortise pocket from both sides of door. Template hole
size: 1/4”. Enlarge to 1-1/8” with a hole saw.
B.
FOR MORTISE CYLINDER.
Drill only on the side of door that has a mortise cylinder. Template
hole size 1/4”, drill only to mortise pocket. Enlarge hole to 1-1/4”
with a hole saw.
C. FOR THUMBTURN OR EMERGENCY KEY.
Drill only on side of door that the thumbturn or emergency key is
be installed on. Template hole size 1/4”, drill only to mortise
pocket. Enlarge hole to 3/4” with a hole saw.
D. HOTEL INDICATOR.
Drill only on side of door that the hotel indicator is to be installed
on. Template hole size 1/4”, drill only to mortise pocket. Enlarge
hole to 3/4” with a hole saw.
E. THRU-BOLT HOLES FOR ROSE TRIM.
Drill holes only if using rose thru-bolted trim Template hole size
5/16”. Drill to mortise pocket from both sides of door.
F. THUMBTURN PLATE ATTACHING SCREWS.
Drill holes only if using sectional trim that requires a thumbturn
plate. Template hole size 1/16” in wood door. If installing in metal
door enlarge to #32 drill size after all holes are drilled and HIT-45
has been removed from door.
G. FOR THRU-BOLTED ESCUTCHEON TRIM.
Drill only if using thru-bolted escutcheon trim. Template hole
size:1/4”. Enlarge to ½” after all holes are drilled and HIT-45 has
been removed from door.
H. FOR SURFACE ESCUTCHEON TRIM.
Drill only if using surface mounted escutcheon trim. Template
hole size 1/16” in wood door. If installing in metal door enlarge to
#32 drill size after all holes are drilled and HIT-45 has been
removed from door.
HIT-45YA2 TEMPLATE GUIDE
FOR USE WITH YALE 8800 SERIES MORTISE LOCKS
LETTERS ON HIT-45YA2 TEMPLATE FOLLOW LETTERS
ON PAPER YALE INSTALLATION TEMPLATE
IMPORTANT: If using HIT-45 clamp for faceplate routing you must remove bevel blocks prior to drilling
function holes. Failure to do so will result in incorrect backset.
ALLWAYS WEAR
EYE AND EAR
PROTECTION
WHEN USING
POWER TOOLS.
