1. SAFETY INFORMATION
• Read the following safety information carefully before attempting to
operate or service the meter.
• To avoid damages to the instrument do not apply the signals which
exceed the maximum limits shown in the technical specifications tables.
• Do not use the meter or test leads if they look damaged. Use extreme
caution when working around bare conductors or bus bars.
• Accidental contact with the conductor could result in electric shock.
• Use the meter only as specified in this manual; otherwise, the protection
provided by the meter may be impaired.
• Read the operating instructions before use and follow all safety
Information.
2. SAFETY SYMBOLS
Caution refer to this manual before using the meter.
Dangerous voltages.
Meter is protected throughout by double insulation or reinforced
insulation.
When servicing, use only specified replacement parts.
CE Comply with EN-61010-1
3. OPERATING INSTRUCTIONS
Link the test line
Check the wires state:
Before pushing the "test" button, certificate the 3 led status
P-E
- led light
P-N
- led light
P-N
- reverse led not light
If indicating light's status is not like this, don't test and check the
wires again.
3.1. Voltage test
When the tester is linked to the power, LCD will update the voltage (P-E)
per second. If the voltage is unusual or not expected value, don't proceed
with the test!
The tester only used in 10% -15% (50Hz).
3
