BATTERY INSTALLATION
WARNING:
To avoid electric shock, disconnect the test leads from any
source of voltage before removing the battery door.
1. Disconnect the test leads from the meter.
2. Open the battery door by loosening the screw using a Phillips head
screwdriver.
3. Insert the battery into battery holder, observing the correct polarity.
4. Put the battery door back in place. Secure with the two screws.
WARNING:
To avoid electric shock, do not operate the meter until the
battery door is in place and fastened securely.
NOTE:
If your meter does not work properly, check the fuses and
battery to make sure that they are still good and that they are properly
inserted.
REPLACING THE FUSES
WARNING:
To avoid electric shock, disconnect the test leads from any
source of voltage before removing the fuse door.
1. Disconnect the test leads from the meter and any item under test.
2. Open the fuse door by loosening the screw on the door using a
Phillips head screwdriver.
3. Remove the old fuse from its holder by gently pulling it out.
4. Install the new fuse into the holder.
5. Always use a fuse of the proper size and value (10A/250V fast blow
for the 10A range).
6. Put the fuse door back in place. Insert the screw and tighten it
securely.
WARNING:
To avoid electric shock, do not operate your meter until the
fuse door is in place and fastened securely.
