Installation, Operation and Parts Manual
MJ-TS6600
7
PACKING, STORAGE AND TRANSPORTATION
Packing, lifting, handling, transporting operations must be performed only by experienced personnel with
appropriate knowledge of the lift and after reading this manual.
2.1 The lift was dismantled into the following 2 parts for transportation
Name
Packed by
Dimension(inch)
Weight(lbs.)
Qty
Control and power unit
Wooden case
21 1/4”*16 15/16“*45 1/4”
118
1
Lift platforms
Carton with wooden base
87"*44 1/2"*9 1/4"
814
1
2.2 Storage
The packs must be kept in a covered and protected area in a temperature range 0f -10
℃
to +40
℃
. They must not be exposed to direct
sunlight, rain or water.
Stacking the packs
We advise against stacking because the packs are not designed for this type of storage. The narrow base, heavy weight and large size of the
packs make stacking difficult and potentially dangerous.
If stacking is unavoidable, use all appropriate precautions:
-never stack to more than 2 meters in height.
-never make stacks of single packs. Always stack pairs of packs in a cross pattern so that the base is bigger and the resulting stack is more
stable. Once the stack is complete, restrain it using straps, ropes or other suitable methods.
A maximum of two packs can be stacked on lorries, in containers, and in railway wagons, on condition that the packs are strapped together
and restrained to stop them falling.
2.3 Opening the packs
When the lift is delivered make sure that it has not been damaged during transportation and that all the parts specified on the packing list
are present.
Packs must be opened adopting all the precautions required to avoid injury to persons.
Take special care with the hydraulic power unit, the control panel and the cylinders.
