7
Basic Operation
Instructions Guide
Please note
that the instructions within this manual will refer to the radio button
number e.g (
Ref.*number*
) in accordance to the diagrams on pages 2-4.
Starting up your radio
Plug the power connector into the system via the “DC IN” port
(
Ref.15
) to charge the radio. Please ensure that the radio is not
exposed to water when it is being charged via mains power.
Charge the radio for approximately 5-6 to fully charge the
internal battery for approx 15 hours of portable charge. Remove
from mains power when using the radio portably and in the
shower. For more information on charging, please see additional
guidance on page
24.
Ensure the handle (
Ref.9
) is extended above the unit as this will
enable you to get the best signal possible before scanning.
Once charged, remove the power cable from the unit and switch
the radio on by pressing the Power button (
Ref.2
).
When switched on for the first time, the radio will display a
“Welcome to Digital Radio” screen, followed by going to DAB/
DAB+ mode to perform an automatic scan for available stations.
The screen will show “Scanning...” as it searches for available
stations and will play the first available station once the scan is
complete.
To change the language of the device, refer to page 23 of the
manual to switch between English and German.
To place the radio into standby mode, press the Power button
(
Ref.2
).