55
GRILL STILL DOES NOT LIGHT
If cleaning the repot does not resolve the issue, remove the fan
panel.
Unplug the IGNITER wire from the red connector on the back of
the Pellet Boss and plug it back in. Ensure the connection is
secure.
Be sure pellets are entering the repot. If the auger is not turning,
check the white auger connection on the back of the Pellet Boss.
Replace the 4-amp fuse. A backup fuse is attached to the inside
back cover of this manual.
If the fuse blows, the fan, auger motor, or igniter has likely failed.
Contact MAK GRILLS Service for assistance.
Be sure the fan works. If it does not, check the fuse on the back
of the Pellet Boss. If the fuse is blown, the fan, auger and igniter
will not operate.
GRILL DOES NOT LIGHT AND DISPLAY READS
“FLAME OUT, CHECK FIREPOT AND HOPPER”
Unplug the grill before accessing the back of the Pellet Boss or
any electrical component.
Indicates the hopper has run out of pellets, or that excessive ash
in the repot is covering the igniter and keeping the pellets from
lighting.
Press any button to end the alarm.
Remove all ash from the repot. Wait till the grill is completely
cold before doing this.
MY GFCI CIRCUIT KEEPS TRIPPING
Cause: Indicates your igniter is failing.
Turn off your igniter (see instructions page 59).
Contact MAK Grills for a replacement igniter.
Follow “Manual Lighting Procedure” while awaiting new igniter.
TROUBLESHOOTING & REPAIRS