Insert a 10cm cable into Halocode.
Take out the wood boards.
1
2
Assemble Halocode.
3
Assemble the power module and the dual color sensor.
5
Assemble the wood boards using a rubber band.
8
Pro tips
Use the sandpaper included to
sand a smooth finish on the
wood board before you start
installing it.
4
Insert two 10cm cables into the left and right ports on the
dual color sensor.
Bind the two boards using a rubber band.
Add the wood board.
6
7
10 cm
20 cm
10 cm
20 cm
Turn the Micro USB port to
the opening of the wood
board. Put down Halocode.
Follow the same steps to install
the rest screws and studs.
Tighten the stud.
M3 *30mm
M3 *14mm
1:1
M3 *30mm
M3 *14mm
1:1
Tighten the studs.
Put Halocode’s
cable through the
hole as shown.
Rotate
Attach a rubber band.
Put the cable
through the
hole as shown.
1
Combine the
two boards.
2
1
Put the dual color
sensor’s cable through
the hole as shown.
Combine the two boards.
Rotate
Attach a rubber
band.
1
2
Combine the two boards.
2
Building Instructions
