POWERPACK PRIME SERIES 1-3 kVA
18
3.2 Start the UPS with mains (AC source)
1.
Press the on/off button of the UPS front panel continuously for more than 1 second. The
buzzer will beep once, the numeric area of LCD display will be lighted in sequence, after a few
seconds of self-diagnosis, the UPS will be turned on in normal mode (line mode) and feed the
output power with constant AC voltage, if the mains abnormal, UPS will shift into battery
mode after self-diagnosis.
2.
When the UPS enters line mode normally, the Inverter LED will be on, the Bypass LED and
Battery LED will be off. There will be no beep from buzzer.
3.
Press the battery test button for 0.5 second, UPS will show the information on LCD display as
followings in a circular order.
3.3 Start the UPS with battery (DC source) only
1.
This UPS can be started directly with DC source (battery), without AC source.
2.
Press the on/off button of the UPS front panel continuously for more than 1 second. The
buzzer will beep once, the numeric area of LCD display will be lighted in sequence, after a few
seconds of self-diagnosis, the UPS will be turned to the battery mode and feed the output
power with constant AC voltage.
Summary of Contents for POWERPACK PRIME SERIES
