24
UDD-SD-112/
Release Date: 25.12.2014/Rev No: 1 /Rev.
Date
: 18.05.2015
4.5 Single UPS Self-Test/Mute Test Operation
1.
When UPS is in LINE Mode, press and hold the self-test/mute key for more than 1 second,
LED light will go off circularly and orderly. UPS comes to self-test mode and tests its status. It
will exit automatically after finishing test.
2.
When UPS is in BAT Mode, press and hold the self-test/mute key for more than 1 second, the
buzzer stops beeping. If you press and hold the self-test/mute key for one more second, it will
restart to beep again.
4.6 Single UPS Panel Function Setting
UPS has setting function. It can run the setting in any mode. After setting, it will become effective
at once when meets some standards. The set information can be saved only when the battery
connected and normally turning off the UPS.
4.6.1 ECO Mode Setting
1.
Enter the setting interface. Press and hold the function setting key
for more than 2
seconds, then come to setting interface, press and hold the inquiring key (
,
)
for
more than half a second(less than 2 seconds), select the function setting, choose output
voltage setting interface, at the moment, the letters “ECO” will flash.
2.
Enter the ECO setting interface. Press and hold the function setting key
for more than
half a second(less than 2 seconds), then come to setting interface of ECO, at this time, the
letters “ECO” will not flash any more. The “ON” (or OFF) will flash. Press and hold the
inquiring key (
,
)
for more than half a second (less than 2 seconds) to determine
whether the ECO function is used or not. If used, the corresponding word is “ON”, if not, the
word is “OFF”. It can be determined by yourself.
3.
Confirm the ECO selecting interface. After selecting ON or OFF, press and hold the function
setting key
for more than half a second (less than 2 seconds). Now, the ECO setting
function is completed and the “ON” or “OFF” will light without flash.
4.
Exit from the setting interface. Press and hold function setting key
for more than 2
seconds, exit from the setting interface and return to main interface.
