24
d) Mounting the spacer
Next, screw together the spacers (30 mm long) for the legs, top and bottom plates as
shown in Figure 33.
A total of 12 screwed spacers are required.
Required tool:
2x SW 5.5mm open-end wrench
Then fit a screwed spacer to each femur counter bearing. Insert the threaded side
through the counter bearing and fix it with an M3 nut. It is sufficient if the spacers are
only tightened by hand.
Do not tighten these screws until the assembly is complete. This way you still have the
possibility to easily adjust everything during assembly.
Do the same with the base plate.
Figure 35 shows the bottom plate from above!
Figure 35
Figure 33
Figure 34
Summary of Contents for MF-4992453
