29
g) Mounting the Receiver and Hexapod Robot Board
Now the radio receiver for the gamepad is connected to the robot board and mounted. The receiver is fixed to the underside of the robot board with the supplied
double-sided adhesive tape.
The receiver and the connection cable must first be connected to each other. Connect the wide receiver plug to the receiver. When connecting the
receiver to the robot board, make sure that the polarity of the connectors is correct.
Required tool:
Scissors
PH2 Phillips screwdriver
Open-end wrench SW 5.5 mm
Plug the cable into the receiver as shown in Figure 42.
The "POWER" and "RX" labels point upwards in the illustration. Use the same colour
sequence as shown in the illustration.
Shorten the double-sided adhesive tape to approx. 25 mm using scissors.
Then peel off one side of the protective film of the adhesive tape and stick this side
onto the robot board.
Now peel off the other side of the protective film and affix the receiver.
Make sure that the housing side with the two red LEDs locks with the "thick" contacts
(see arrow in the illustration) of the loudspeaker.
If the housing protrudes too far into the contacts of the loudspeaker, the housing will
press against the contacts of the loudspeaker when mounting the circuit board.
Figure 42
Figure 43
Figure 44
Summary of Contents for MF-4992453
