34
Now mount the counter bearings.
The U holder has two holes, use the hole facing the cable opening.
When pressing in the dowel pins, proceed in the same way as when pressing in the
dowel pins of the base plate.
The distance between the bearing and the plastic part here is 1.5 mm. You can also use
an Hexagon key as a distance gauge here.
Then screw the spacer on each leg with a M3 x 6 mm screw (small head diameter
5 mm) as shown in Figure 53.
The 1.5 mm hexagon key is placed between the ball bearing and the plastic part and
the cylindrical pin is pressed in until it stops.
Also, in this case, press the cylindrical pins only alternately (first one side then the
other) piece by piece into the plastic so as not to tilt the holder.
If you hold the robot at an angle, you can hang the Hexagon key over the
cylinder pin without it falling down.
Figure 55 shows the Robobug with the legs fully assembled and in the basic position.
Figure 55
Figure 53
Figure 54
Summary of Contents for MF-4992453
