4 - 8
('*(
3UH,QVWDOODWLRQ*XLGH
4.3.3
Environment
A sub-standard environment can cause control, machine, and component
failures of all types.
Do NOT locate the machine:
•
In direct sunlight.
•
Near a source of heat.
•
In a place subject to large temperature variation.
•
Near a source of severe vibration, which may affect accuracy and
alignments.
-
If the machine must be located in such an environment, we recom-
mend a separate foundation with a 25mm expansion strip to absorb
the vibration.
•
Near a source of extreme metallic dust, like grinding machines.
The machine location should meet or allow for the following conditions:
•
Dust-free, well-lighted, and free of temperature changes
-
Ambient temperature – 10 to 35°C, optimum 20±1°C.
-
Temperature fluctuation – less than 1°C/30 minutes.
-
Relative humidity – 35 to 75% (no condensation).
•
Freely flowing air
•
Available floor and bench space for storing raw and finished work-
pieces, tooling, and inspection equipment
•
Enough room for maintenance work. Adequate space around machine
and clearance to fully open cabinet doors.
•
Adequate and proper sized utilities are available: electrical power sup-
ply, clean, dry air supply, and water.
•
Drainage for the overflow and tank cleaning drains with provisions for
disposal of the used dielectric fluid.
•
A foundation flat and strong enough to support the weight of the
machine without appreciable deflection.
Summary of Contents for EDGE-2
